Need help?Do you have a question about the BSR EQ-3000 and is the answer not in the manual?
General| Signal to Noise Ratio | 90dB |
|---|---|
| Input Sensitivity | 150mV |
| Output Level | 1V |
| Gain | ±12dB |
| Type | Graphic Equalizer |
| Bands | 10 |
| Input Impedance | 50k ohms |
| Power Supply | 120V AC, 60Hz |
| Frequency response | 20Hz to 20kHz |
| Frequency Bands | 10 |
| Output Impedance | 600 ohms |
Covers safe operation, placement, electrical connection, and maintenance instructions.
Covers unit placement, ventilation, and AC power connection requirements.
Essential steps before operating the equalizer for the first time.
Specifies power needs and voltage requirements for the unit.
Step-by-step guide for connecting amplifiers, receivers, and tape decks.
Details the function of each control and button on the equalizer's front panel.
Explains the operation of frequency level controls and spectrum analyzer adjustments.
To Next Page