Quick Reference Guide QRG
3.3 Adjust password level
The password level Operator is set after switching on the sensor.
You have to be logged in as Administrator to carry out sensor set-
up and the sensor must be in set-up mode (blue border strip).
The procedure for selecting the password levels is described in the
following, e.g. for commissioning or operating.
1. Press the button MENU on the commander of the sensor for at
least 3 seconds.
2. Afterwards the menu will be displayed. Mark the change user
entry and press ENTER for confirmation.
3. Use the up or down arrow keys to select the password level
Administrator and press ENTER for confirmation.
4. You will be asked to enter the password afterwards.
Enter the valid password 00002.
Use the arrow key right to select the last place of the
password. Now press the arrow keys up or down as often as
the 2 appears at this place.
5. Confirm the entry by pressing ENTER.
You are now logged into the selected user level. You can now
adapt the parameters that can be accessed from this level.
Quick Reference Guide EDV no.: MD.341.01.01
ekr 500 Plus with CLS Pro 600 Issue Date: 31.03.2009 Page: 12/18
To Next Page
Loading...
Need help?
General
