If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
Where to put your phone
• Place the base within
3 metres of a mains power
socket and 3 metres of a
phone socket so the cables
will reach.
• Make sure it’s at least a
metre away from other
electrical appliances to avoid
interference.
• Don’t place the phone or
base in a bathroom or other
humid area.
• The product works by
sending radio signals
between the handset and
base. The strength of the
signal depends on where you
position the base. Putting it
as high as possible can help
give you the best signal.
IMPORTANT
• Don’t connect the phone line
to a phone socket until the
handset is fully charged.
• The base station should
be plugged into the mains
power socket all the time.
1. Plug the mains
power adaptor
into the base.
2. Plug the other end
of the power adaptor
into the wall power
socket and switch on.
Quick set-up guide4
1 Plug in
The phone line cord is pre-installed but don’t
plug the other end into the wall socket yet.
1
2
1662 BT4000 UG [3].indd 4 09/04/2013 15:03
To Next Page
Loading...
Need help?
General
