If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
26
Under the call control menu are the features Do not
disturb and Block calls. Do not disturb allows calls
to be received silently with minimal notification.
Set-up Do not disturb
1. Select
Menu, scroll to Call control and
press
OK.
2.
Do not disturb is displayed, press OK.
3. Press
or to display On or Off and press OK to
select. The chosen setting will be displayed and you
will hear a confirmation tone.
Block nuisance calls
The BT4000 can block calls from certain call types,
e.g. international calls or from specific numbers
to help prevent nuisance calls. You can store up to
10 specific blocked numbers. Calls from numbers
stored in your blocked calls list cannot leave a
message on your answer machine but calls blocked
by call type can.
1. Select
Menu, scroll to Call control and
select
OK.
2. Press
to display Block calls and press OK.
Call control settings
When set to On, the base and
handset ringer volumes (on
all handsets registered to the
base) will be set to Off. The
handset backlight will not come
on when the phone rings and
the only tones that the handset
will emit are the battery low
and out of range warnings. The
base call screening volume and
message alert will also be set
to Off.
You can set Do not disturb to
On or Off. The default setting
is Off.
When set to On, the idle screen
will display
DO NOT DISTURB
instead of the number of
missed calls or the handset
name if there are no missed
calls presented.
Please note, other products
connected to the line are not
compatible with this feature
and will still ring.
For more information and
general advice on handling
unwanted calls please go to
bt.com/unwantedcalls
1662 BT4000 UG [3].indd 26 09/04/2013 15:03
To Next Page
Loading...
