If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
Chapter4
If you need some help, call us on 0800 145 6789* or go to bt.com/producthelp
Where to put your phone
• Place the large base close
enough to a mains power
and telephone socket so that
the cables will reach.
• Make sure it’s at least a
metre away from other
electrical appliances to avoid
interference.
• Don’t place the phone or
base in a bathroom or other
humid area.
• The product works by
sending radio signals
between the handset and
base. The strength of the
signal depends on where you
position the base. Putting it
as high as possible can help
give you the best range.
IMPORTANT
• Don’t connect the phone line
to a phone socket until the
handset is fully charged.
• The base station and charger
should be plugged into
the mains power socket
all the time.
Quick set-up guide4
1 Plug in
1 Plug the mains power
adaptor into the base,
with the cable clipped
in the groove provided.
Turn the cable when
clipping into the groove
so that the narrow part
fits between the clips
before turning the
cable back to secure.
2 Plug the other end of the
power adaptor into the
wall power socket and
switch on. You will hear a
confirmation tone.
1
2
The phone line cord is pre-installed but don’t
plug the other end into the wall socket yet.
To Next Page
Loading...
Need help?
General
