Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 11- 1
Electric steering motor – 1730
General
11- Electric steering motor – 1730
11.1 General
The steering motor is located on the drive assembly cowling. It receives
signals from the steering generator located in the drive panel. The
steering motor is equipped with a gear working directly upon the gear
ring on the drive axle. It is also equipped with two carbon brushes.
11.2 Replacing the steering motor
To open and close the motor compartment, see section P1 in this man-
ual.
11.2.1 Dismantling
• Switch off the truck by press the 0 key on the keypad.
• Disconnect the steering motor electrical contact from the tank console.
• Unscrew the screws holding the gear wheel.
• Lift away the steering motor.
• Unscrew the screws holding the gear wheel.
• Pull off the gear with a gear puller.
11.2.2 Assembling
• Replace the O-rings if required.
• Tap the gear wheel onto the steering motor.
• Apply Loctite 243 on the thread.
• Tighten the nut to a torque of 180 Nm.
• Close up the nut in the axle.
• Install the steering motor in the truck.
• Tighten the steering motor to a torque of 40 Nm.
• Connect the connector.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...