BT REFLEX RR E 1-3 - 10.4 Bearing replacement; 10.4.1 Dismantling

Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 10- 3
Electric pump motor –1710
Bearing replacement
10.4 Bearing replacement
10.4.1 Dismantling
Motors without pumps.
• Loosen the screws (23) and remove the protective plate (8).
• Loosen the stud screws (20) using tool 08-15444.
• Remove the shield (3) and washer (7).
If both bearings are to be replaced follow the points below. When only
replacing the pulse sensor bearing continue with A.
• Remove the screws (22).
• Lift the rotor (4) out of the stator (1).
• Dismount the shield (2) radial seal (19).
• Remove the circlip (16) and support ring (17).
• Pull off the bearing with a puller.
A)
• Pull off bearing (5) with a puller.
3
5
2
3
7
21
6
22
16
17
19
2
411
1
10 36
9
20
8
26 25
24 27
13
30
28
D N
https://www.forkliftpdfmanuals.com/