Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B/E, RR B/E CC 24- 41
Electronic card – 5710
Warning Codes without registration
1. Resetting parameter 25:
- See the section “Programming” in this document.
- The service intervals can be checked in the section Preventive
maintenance.
Temperature sensor B1 in drive motor M1
1. Check that the ventilation is okay, especially the fan M10 in the
motor compartment.
Code 29
Description Service time (S) is zero
Error mode No corrective action
Error cause 1. Time for servicing
Comments Reset with parameter 25
Code 40
Description Warning temperature for drive motor
Error mode Maximum current reduced
Error cause 1. Overheated drive motor M1
2. Faulty temperature sensor/wiring
3 Defective drive regulator, A1
Comments
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...