T-code Valid from serial number
403-404 713962-
Date Order number
2005-09-09 218920-040
18- 2 Service Manual REFLEX RR B,E RR B,E CC © BT Europe AB
Fork/support arm wheel – 3550.2
Assembling the drive wheel
18.3 Assembling the drive wheel
• Press the wheel on axle using tool 08-14044.
• Fit the lock washer (5) and nut (4).
• Tighten the nut (4) so that the bearing rotates without any play. The
threads should be greased prior to assembly.
• Lock the nut by folding down one of the washer’s tabs into the nut’s
cut-outs.
• Fit the O-ring (3).
• Fit the guard plate (2) and secure in position with the bolts (1).
18.4 Dismantling the wheel bearing
• Remove the sealing ring (9) and the inner part of the bearing (6, 8).
• Use a “soft” punch of brass or the like to knock out the bearing cups
(6, 8).
18.5 Assembling the wheel bearing
• Fit the bearing cups in the hub using assembly tool 08-14044-2.
• Grease the bearing with bearing grease and fit the wheel.
• Fit the sealing rings in the hub using assembly tool 08-14044-1.
https://www.forkliftpdfmanuals.com/
To Next Page
