Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 21- 37
Electrical system – 5000
Functional description
21.4.3 Choice of travel direction
The travel direction can be selected in three ways.
On the control console
When the S26 control is pressed down, voltage is fed from the switch to
A5. If the control is held down for at least three seconds, the truck runs
at crawl speed.
On the left-hand handle
When control S28 is pressed, voltage is fed from the switch to A5, caus-
ing the truck to change direction of travel. This control can only be used
to change direction of travel after the choice has been made on the
steering wheel console. It does not allow the crawl speed function to be
selected either.
On the accelerator
When the pedal is pressed down on the right-hand side (fork direction)
voltage is fed from switch S27 to A5. To switch the truck’s travel direc
-
tion, press down on the left-hand side. The pedal does not allow the
crawl speed function to be selected.
The display shows the direction of travel.
Designation Diode number
DRIVE, FORK DIRECTION 104
DRIVE, STEER WHEEL
DIRECTION
105
Designation Diode number
DRIVE,
CHANGE DIRECTION
111
Designation Diode number
DRIVE, FORK DIRECTION 106
DRIVE, STEER WHEEL
DIRECTION
107
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...