Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 41- 15
Positioning equipment – 9390
Parameters
41.11.6 Parameter 7
Programming the largest and smallest permitted programming dis-
tance between the levels collect and leave.
• State parameter 7 and press the LOAD button. The display shows
the previous programmed value for min. distance. Enter the new
value using the numerical keys, (e.g. 030 = 30 mm). The permitted
max/min. values are shown in table “Programming parameters”.
• Press the LOAD button. The display shows the previous pro-
grammed value for max. distance. Enter the new value using the nu-
merical keys, (e.g. 150 = 150 mm).
• Press the PROG button to save. The display shows P_.
41.11.7 Parameter 8
Resets all the parameters to the factory settings.
NOTE!
Reset to factory settings after upgrading to later program version.
• State parameter 8 and press the LOAD button. The display shows
no value.
• Press the PROG button until the display stops showing PP. Turn the
ignition key on and off to start the new program.
41.11.8 Parameter 9
• Programming the leave/collect levels’ braking distances.
• State parameter 9 and press the LOAD button. The display shows
the braking distance for lower. Enter the new value using the nu
-
merical keys, (e.g. 050 = 500 mm).
• Press the LOAD button. The display shows the crawl speed for lift.
Enter the new value using the numerical keys, (e.g. 030 = 300 mm).
• Press the PROG button to save. The display shows P_.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...