Valid from serial number T-code
713962- 403-414, 669-671, 716-718
Order number Date
218920-040 2005-06-01
© BT Europe AB Service Manual REFLEX RR B,E RR B,E CC 35- 5
Main mast –7100
Assembling the mast
• Guide the mast slowly to the reach carriage (1).
• Stop approximately 100 mm from the reach carriage (1).
• Insert the feeder hose (2) into the reach carriage.
• Guide in the mast fully and lower it so it rests on the pins (3).
• Position the top section of the pin holder and secure loosely with the
four bolts (4).
• Screw in the bolts (5) that hold the mast in the bottom of the reach
carriage, just far enough so that the shims still have space.
• Position the shims (6) and move the overhead crane in the direction
of the forks so that they fasten with the mast.
• Tighten the bolts (4 and 5) with the following torque:
B/E1-B/E8
Stud bracket bolt (4) 197 Nm
Bottom bolt (5) 385 Nm
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...