2 – 2 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
General introduction
Warning symbols
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
2.2 Warning symbols
The following warning symbols are used throughout the service
manual:
DANGER!
DANGER! means there is a risk of accident potentially leading to
death or serious injury and material loss or damage. This is always
indicated by the warning symbol.
WARNING!
WARNING! means that there is a risk of damage to components that
are sensitive to electrostatic discharge.
Heed applicable ESD safety precautions.
Note:
Note: means there is a risk of material loss or damage if the
instructions are not followed. It is also used to call for attention to
various points.
2.3 Pictograms
2.3.1 Screws/Nuts
Wherever possible, pictograms have been used to describe certain
work operations.
Pictograms are primarily used for operations that require loosening or
tightening of screws:
The pictograms contain information about the screw head type and
have arrows that show if the screw should be loosened or tightened.
The text below the pictograms provide additional information, such as:
‘s’: spanner size, ‘n’: number of screws and, where required, ‘T’: the
recommended tightening torque.
× n
s mm
https://www.besttruckmanuals.com/
To Next Page
Loading...
