BT SWE200D - Factory Pre-Set Operator Parameters

6 – 12 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Functions and parameters
Parameters
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
Factory pre-set operator parameters
Upon delivery from the factory, the various operator profiles have
different values for operator parameters 4, 5 and 6. See the table
below.
The values for operator profiles 1 and 4-10 are the default values.
Note:
When replacing the firmware, the factory presettings of operator
profiles 2 and 3 are lost. In this case, all operator profiles are assigned
the same default values, i.e. the default values of operator profiles 1
and 4-10. To regain the factory settings, these values must be entered
anew, either manually or via a PC/PDA.
Operator
profile
Parameter Factory
setting
PIN
code
Operator profile
1
4 70 1
5 90
6 90
Operator profile
2
4 50 2
5 90
6 80
Operator profile
3
4 100 3
5 100
6 100
https://www.besttruckmanuals.com/