Chassis 0000
Motor mounts 0450
© BT Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D 8 – 3
Order no.. Date Valid from serial no. T code
258946-120 2012-08-30 6061850- 841×842×843
8.2 Motor mounts 0450
8.2.1 Replacing springs (not applicable for
SWE120S)
Proceed as follows to replace the springs that press the drive unit
against the ground:
1. Remove the covers and the battery door.
The top cover is secured with Velcro tape. Be careful when
detaching the cover. Use of a suitable tool is recommended.
2. Lift out the battery.
3. Disconnect the cables to the drive motor and the pump motor and
also the wiring harness.
4. Disconnect the cable duct.
5. Unfasten the battery connector and the battery cable bracket.
6. Install the threaded M16 bar. See section "Tools".
7. (1) Washer and nut on the top side. (2) Screw the shaft into the
1
2
https://www.besttruckmanuals.com/
To Next Page
Loading...
