8 – 4 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Chassis 0000
Motor mounts 0450
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
threaded hole and tighten with the nut.
8. Change the upper stop screws for M8 x 120, washers are not
needed.
9. Remove and discard the screws to the upper bracket.
10. Remove the lower screws.
11. Compress the spring assembly using the threaded bar until the lips
are clear.
12. Unload the springs by prying up the bracket using the threaded bar.
Note:
Check that the bushings do not get stuck or become damaged during
reassembly.
https://www.besttruckmanuals.com/
To Next Page
Loading...
