4 – 10 Repair manual SWE100, 120, 120L, 120S, 140, 140L, 200D © BT
Installation
Setting the parameters
T code Valid from serial no. Date Order no.
841×842×843 6061850- 2012-08-30 258946-120
Verifying the parameter adjustment for free
ventilated batteries
(Lead/acid batteries)
1. Charge the battery.
2. Use the truck in its normal application until the battery indicator
shows a discharged battery (0% on the display).
3. Disconnect the battery from the truck and let the battery rest for at
least two hours.
Note!
Do not charge or discharge during this time.
4. Measure the acid weight of the battery at room temperature.
If the acid weight is under 1.15 g/cm
3
, the parameter must be
reduced. A value substantially above 1.15 g/cm
3
reduces the risk of
damage to the battery. At the same time the operating time of the
truck is reduced. If a longer operating time is desired, the
parameter value can be increase by up to one unit.
Note!
Each change must be followed by renewed verification of the
parameter setting.
Verifying the parameter adjustment for valve
controlled batteries
(Hawker/Exide)
1. Charge the battery.
2. Use the truck in its normal application until the battery indicator
shows a discharged battery (0% on the display).
3. Disconnect the battery from the truck and let the battery rest for at
least two hours.
Note!
Do not charge or discharge during this time.
4. Measure the voltage of the battery at room temperature.
If the voltage is under U
end
(see table below) the parameter value
must be reduced. A value substantially above U
end
reduces the
risk of damage to the battery. At the same time the operating time of
the truck is reduced. If a longer operating time is desired, the
parameter value can be increase by up to one unit.
Note!
Each change must be followed by renewed verification of the
parameter setting.
Battery type Battery voltage at rest, U
end
Hawker Evolution/Exide 24.24 V
https://www.besttruckmanuals.com/
To Next Page
Loading...
