BTG EKOS - Page 42

Using an Infusion Stand or EKOS™ CU 4.0 Cart
38
• The infusion pumps and Control Unit are positioned as low as practical
on the pole.
• Access to the infusion pumps is not blocked when the Control Unit is
attached.
2. Place the pole inside the mounting bracket that is located on the back of the
Control Unit (see Figure 31).
Figure 31. Pole Inside Bracket
3. Turn the knob clockwise until it is tight (see Figure 32).
Figure 32. Turn Knob
4. Ensure the Control Unit is securely attached to the pole and cannot fall off the
stand (see Figure 33).