btsr SM-DIN/MULTILOOP/ETH - Page 31

Installation and Connections
SM-DIN/MULTILOOP.. - 2.11 -
DF DISPLAY CONFIGURATION
Enter the BOARD SETUP menu.
Select DF DISPLAY
/
To change the DIAPERFEEDER display orientation from NORMAL to
FLIP mode.
To select the parameter of the next position
3 sec to confirm and go back to BOARD SETUP menu
DF ENDSCALE CONFIGURATION
Enter the BOARD SETUP menu.
Select DF ENDSCALE
/
To change the DIAPERFEEDER devices endscale value: 1000 cN or
100 cN.
To select the parameter of the next position
3 sec to confirm and go back to BOARD SETUP menu
BOARD SETUP
→
DF ENDSCALE
BOARD SETUP
→
DF DISPLAY