Instruction Manual
26
06/23
Proceed as follows:
Use the
d
and
e
buttons to select
Nodes Populated
and then
80
. Press
b
.
Press
b
again.
Use the
e
button to select
82
. Press
b
.
Press the
e
button twice to select
Save and Enter
. Press
b
.
Use the
d
button to select
Nodes Populated
and then
81
. Press
b
.
Press
b
again.
Use the
e
button to select Press
b
. Press
b
.
Press the
e
button twice to select
Save and Enter
. Press
b
.
Use the
d
button to select
Nodes Populated
and then
82
. Press
b
.
Press
b
again.
Use the
e
button to select
81
. Press
b
.
Press the
e
button twice to select
Save and Enter
. Press
b
.
Use the
e
button to select
Clean
. Press
b
.
Press
c
to return to the home screen.
If there are four connected units, one must first be moved to node 10 as an empty location in order to
vacate the address for the other unit to be connected. Then the desired unit can be moved to the
preferred location, and the unit in node 10 may then be moved to the vacated node position.
It is necessary to save the node allocations before exiting from this screen.
After saving, it is possible to remove unused output units from their old node allocation by use of the
Clean
option.
If all nodes are accidentally disconnected, please turn the unit off and on again, it will reallocate a unit
to node 80.
To Next Page
Loading...
