13
System inspection and maintenance
Logano G515 – 6 720 647 208 (2014/09)42
13.7 Inspection and maintenance logs
The inspection and maintenance logs provide an overview of the
required inspection and maintenance work.
▶ Initial and date the inspection operations completed.
The inspection and maintenance logs can also be used as templates.
Inspection work Page Date:____________ Date:____________
1. Check general condition of heating system
2. Visual inspection and function check of the heating system
3. Check fuel and water-carrying components of the system for:
•Leaks during operation
• Visible signs of corrosion
• Signs of aging
4. Check the combustion chamber and heating surfaces for contamination.
Shut down the heating system first.
39
5. Check the burner ( burner documentation)
6. Check the flue gas and venting system for proper operation and safety
(see burner documentation)
7. Check the operating pressure and inlet pressure of the diaphragm
expansion vessel for heating systems
41
8. Check the function of indirect-fired heater and rod ( tank
documentation)
9. Check the control panel setting (see control panel documentation)
10. Record the final checks of the inspection work, incl. measurements and
test results
Confirm professional inspection
Company stamp/signature Company stamp/signature
If during inspection work conditions are identified that require additional service and maintenance, perform this work on an as-needed
basis. If make-up water is added, the quality of this water must correspond to the specifications in the enclosed operating manual.
To Next Page
Loading...
Need help?
General