Basic functions7
28 Operating instructions RC30 programmable room thermostat • Issue 02/2006
We reserve the right to make any changes due to technical modifications.
7.4.2 Single DHW loading
If the LED in the "DHW" button lights up, the DHW temperature has
fallen below the set value. Should you require a large amount of
hot water, proceed as follows:
Press "DHW".
The LED in the "DHW" button flashes, and single DHW heating
begins.
Depending on the size of the DHW cylinder and the boiler rating,
the DHW will be available after approx. 10 to 30 minutes. With
instantaneous water heaters or combination boilers, DHW is
available almost immediately.
DHW
SGL LOADING
ACTIVE
USER NOTE
If you have started this function in error, press "DHW" again.
Reloading will then be terminated.
To Next Page
Loading...
