Buffalo AirStation WHR-HP-G54 - Connecting to a Preexisting Network

57
Connecting to a Preexisting Network
Add an AirStation without changing your existing LAN configuration
1. Set the AirStation into Access Point Mode by moving the switch on the bottom from
AUTO to BRI.
2. Connect one of the AirStation’s LAN ports to an existing router or switch on your
network. Nothing should be plugged into the WAN port.
3. Open LAN Settings - LAN Port Settings and congure the following settings:
IP Address =[192.168.11.1] (Specify an unused network address from the existing LAN.)
Subnet Mask=[255.255.255.0] (Use the same Subnet Mask as the existing LAN.)
DHCP Server Function=[Disable]
4. Restart PC.