Bully Dog 40417 - Detailed Instructions

40417 GT PLATINUM
32
PHYSICAL INSTALLATION
Detailed Instructions
1. Connect The OBDII Adapter Plug to the OBDII Port.
• Find the OBDII port in your vehicle. As shown in the illustration, the specic location of the port can vary between dierent vehicles, but it is always
somewhere under the driver’s side dash. The OBDII port will
have the same shape as the end of the adapter plug.
• Once you have found the port, simply connect the adapter
plug to it.
2. Connect The Power Cable. The power cable is not
really optional if you want to enjoy the originally
designed functions of the GT Platinum. It is only
optional under one of the following circumstances:
You do not want to keep the GT Platinum permanently
installed and plan on disconnecting it when you are not
actively using the unit.
You want the GT Platinum to remain on at all times,
regardless of the eect that this could have on your car
battery
You prefer physically switching the GT Platinum on and o
and do not want it to automatically power down when you
turn the key to the o position.
Otherwise, in order for the GT Platinum to work as originally designed, it is very important for the power cable to be installed
as described below:
1. Locate an ignition fuse.
• An ignition fuse is one that is controlled by the position of the key.
• Sometimes we call this a “key-on” or “key-o” fuse.
• The fuse that controls the front windshield wiper is usually perfect, but any fuse that turns o when the key is turned o will work just ne.
• Every vehicle is dierent. There is no way to provide wiring diagrams for all vehicles. You will be able to nd the information for your vehicle
in the owner’s manual or online.
• Some vehicles have a fuse box inside the cab. If your vehicle does not have a fuse box inside the cab, you will need to locate the re wall and
connect the power cable to the fuse box under the hood.
2. Connect the power cable to the fuse.
• You may have received a fuse tap with your GT Platinum. See below for an illustration and instructions on using the fuse tap to install the
power cable.
• You can also simply put the power cable into the fuse box along with the fuse that is normally installed in that location. See the diagram and
picture for more information.
• If you did not receive a fuse tap, but prefer to use
one to install your power cable, you can purchase
one at your local auto parts store. Be sure to ask for
installation instructions if none are included with the
fuse tap.
Using the Fuse Tap and Spade
1. Find and pull the fuse that you are going to use to insert the GT Platinum
Power Cable.
2. Slip the fuse tap over the prong on the fuse.
3. Fit the spade over the fuse tap and crimp them together with pliers.
4. Put the tapped fuse back into the fuse box.
OBDII Plug
Main Cable
Power Wire
OBDII Adapter Plug Installation Diagram
GT