40417 GT PLATINUM
58
UNINSTALLING - RETURNING TO STOCK
What does this mean?
“Uninstalling the Tune” and “Returning to Stock” are different ways to describe the same thing: writing the original (stock)
information to the engine computer so it uses the settings that it used before you installed your GT Platinum. Doing this also
sends a signal to the GT Platinum to let it know that it is no longer installed on a vehicle, which will allow you to install the
tune at a later time. The GT Platinum will not allow you to install if the tune has already been installed on a vehicle.
When to Return to Stock
You should return to stock in ALL of the following situations:
• EVERY TIME you take your vehicle in for any type of service. It is a very common practice for the engine computer to be “ashed” (re-
programmed) during all types of service, even routine maintenance. If the tune from the GT Platinum is still installed when the engine
computer is ashed, it can cause problems when you want to use your GT Platinum in the future.
• If you want to install the GT Platinum on a dierent vehicle. For instance
If you have a second vehicle and want to try the GT Platinum on it. The GT Platinum can only be used on one vehicle at a time.
If you want to let a friend try the GT Platinum.
If you have decided to sell the GT Platinum to someone else.
• If the battery is having problems and could possibly go dead. Make sure to connect a battery charger while returning to stock to prevent
any complications that can be caused by interrupting the GT Platinum while it is returning your vehicle to stock.
• If you need to disconnect the battery for any reason.
IMPORTANT NOTE: If you do not return your vehicle to stock, you may have to call in to technical support to have your GT Platinum reset. There is a mandatory fee
for this service.
To Next Page
Loading...
