LOWLANDER HD MK2 & WIDEBODY MANURE SPREADER – INSTRUCTION & SPARES MANUAL
Page 11
1.2 COUPLING OF HYDRAULIC HOSES
Fit the two hoses for the floor drive hydraulic motor (one to feed and one for return) to double spool valve
on tractor. Choose position of spool lever for ease of control to obtain floor movement to rear. Reversing
of floor is done by selecting the opposite position of the hydraulic control lever. Universal quick release
probes are fitted as standard to hose ends. Mark hose as required to assist in the future coupling for
correct position of feed and return.
NOTE: CHECK DIRECTION OF FLOOR BEFORE LOADING.
Do not run floor in reverse with full load. Speed of floor in reverse is at MAXIMUM.
Only reverse floor for a few seconds.
When a slurry door is fitted connect the hydraulic hoses to a double spool valve and select the hose
positions to suit the operator to open and close the door.
Fit hydrualic brake hose to trailer brake valve on tractor (male fitting). A universal female brake coupling is
fitted as standard to the hose end.
Ensure the braking system is connected and that it functions correctly before moving.
To Next Page
Loading...