BUNNING 150HD - Amount of Oil Required to Fill Gearbox

LOWLANDER HD MK2 & WIDEBODY MANURE SPREADER – INSTRUCTION & SPARES MANUAL
Page 28
4. Check condition of rotor blades and paddles. Repair when there are loose bolts, cracked welds,
chipped, bent or broken blades or paddles. Replace when any components are worn within 1 inch (25
mm) of flighting.
5. Clean machine.
6. Check general hardware/bolt tightness. Retighten if necessary.
It is recommended to apply waste oil to the floor chains periodically when spreading dry material and
particularly at the end of the spreading season. This assists in the smooth running of the machine and
prolongs the working life of the components.
7. Check bearings in gearboxes.
8. Remove the floor drive gearbox from drive shaft, clean both, add copaslip to the drive shaft and
gearbox and replace.
2.3 AMOUNT OF OIL REQUIRED TO FILL GEARBOX
Please use EP90 gear oil
LITRES GALLONS LITRES GALLONS
RT800/60/32 10.5 2.8 12 3.2 FLOOR DRIVE
RT1000/70/32 12.7 3.4 14 3.7 FLOOR DRIVE
SRT 18 13.5 3.6 AUGER DRIVE
SRT 18 ALL-IN-ONE GEARBOX 20 5.3 BEATER DRIVE
SRT 20 ALL-IN-ONE GEARBOX 20 5.3 BEATER DRIVE
GEARBOX
TVA
HBD
REFERENCE