Burkert 8020 - 4. Maintenance; 4.1 Maintenance and Cleaning; 4.2 Order Codes for Spare Parts; 4.3 Order Codes for Complete Sensors



ENGLISH

 
If the sensor has been installed properly and is used under correct operating conditions it
is maintenance free. Nevertheless if contamination or clogging occurs, clean the wetted
parts (paddle-wheel, axis, bearings) with water or any PVDF compatible cleaning agent.
 
 
 
Gasket set (1 FKM + 1 EPDM)

EN175301-803 cable plug with cable gland (type 2508)

EN175301-803 cable plug with NPT 1/2'' reduction (type 2509)

    
12-36 VDC FKM Hall, short finger EN175301-803 cable plug

12-36 VDC FKM Hall, long finger EN175301-803 cable plug

via transmitter FKM Low Power Hall, short finger EN175301-803 cable plug

via transmitter FKM Low Power Hall, long finger EN175301-803 cable plug

None FKM Coil, short finger EN175301-803 cable plug

None FKM Coil, long finger EN175301-803 cable plug


Bürkert & Cie
Rue du Giessen
67220 TRIEMBACH-au-VAL
FRANCE