Burkert 8025 - Resetting the Two Volume or Mass Totalizers; Resetting the Two Totalizers of the Done Dosings

115
Operating and functions
10.7.28 Resetting the two volume or mass totalizers
The function allows for resetting the two volume or mass totalizers.
Both totalizers are reset upon confirmation of "SAVE YES" when leaving the Parameters menu.
RESEt RESEt N
BAtCH
0......9
→ Choose to reset or not the two totalizers.
→ Confirm
RESEt Y
tOtAL
Fig. 89 : Diagram of the "TOTAL" parameter of the sub-menu "RESET"
The daily totalizer can be reset from the Process level. See chap. 10.6.
→ If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER
to save the settings or not and go back to the Process level.
10.7.29 Resetting the two totalizers of the done dosings
The function allows for resetting the two totalizers of the done dosings.
• Both totalizers are reset upon confirmation of "SAVE YES" when leaving the Parameters menu.
• A dosing which has been aborted or interrupted by the generation of an "ERROR [T]" alarm is not
counted.
RESEt RESEt N
HiStORiC
0......9
→ Choose to reset or not the two totalizers.
→ Confirm
RESEt Y
BAtCH
Fig. 90 : Diagram of the "BATCH" parameter of the sub-menu "RESET"
The daily totalizer can be reset from the Process level. See chap. 10.6.
→ If you do not want to adjust another parameter, go to the "END" parameter of the Parameters menu and press
ENTER
to save the settings or not and go back to the Process level.
English
Type 8025 - 8035 - SE35 BATCH