28
Installation and commissioning
Type 8700, 8701, 8703, 8705
→ Fit the washer [C] and screw the fitting [B] to the device.
C
B
→ Insert the line and manually tighten the nut [A].
A
→ Finish tightening the nut with a suitable wrench to ensure the
mounting is sealed.
7.8. Electrical installation
danger
Risk of injury due to electrical shock
• Shut down and isolate the power supply before carrying out any
work on the system.
• Observe all applicable accident protection and safety
regulations for electrical equipment.
English
To Next Page
Loading...
