48
Packaging, Storage, Transport
Type 8700, 8701, 8703, 8705
12. PACKAGING, STORAGE,
TRANSPORT
12.1. Packaging, Transport
note
Damage due to transport
Inadequately protected equipment may be damaged during
transport.
• Remove all cables, connections, separate filters and installation
material.
• Clean and air contaminated devices.
• Protect fluid connections from damage by fitting protective caps
and seal.
• Pack the device in two suitable bags, sealed with protective film.
• During transportation protect the device against humidity and
dirt in shock-resistant packaging.
• Do not expose the device to temperatures outside the storage
temperature range.
12.2. Storage
note
Poor storage can damage the device.
• Store the device in a dry place away from dust.
• Storage temperature: -10 °C to +70 °C.
13. RETURNING THE DEVICE
No work or tests will be carried out on the device until
there is a valid Contamination Declaration.
The Contamination Declaration can be downloaded from our
Homepage or requested from your local after-sales service.
www.buerkert.fr
Service
Servicing/Maintenance/
Commissioning
Contamination Declaration
To return a device already in use, a returns number is
required.
If you would like to return a device already in use to Bürkert, proceed
as follows:
→ Complete the Contamination Declaration.
→ Send the declaration to the address indicated on the form:
Bürkert will fax or e-mail you a returns number.
→ Pack the device in consideration of the information in chap. 12.1.
→ Return the device to Bürkert with the Contamination Declaration,
quoting this returns number.
Adress:
Bürkert Fluid Control Systems
Corporate Quality / Complaint Management
Chr.-Bürkert-Str. 13-17
D-74653 Ingelfingen
Tél. + 49 (0) 7940 - 10 91 599
Fax + 49 (0) 7940 - 10 91 490
E-mail: service.international@burkert.com
English
To Next Page
Loading...
