Burmester 102 - FREQUENTLY ASKED QUESTIONS

9
FREQUENTLY ASKED QUESTIONS
What kind of sources can I connect to the inputs of the 102?
The balcanced output (22), as well as the unbalanced outputs (23, 24) can be connected to a preamplifier and a
integrated amplifier.
Both of the 102’s digital outputs can be connected to devices with digital inputs. Thereby, both of the digital outputs
are delivering the data of the selected digital input.
How can I turn the 102 on and off?
The AC mains switch (18) needs to be set to ON to maintain the device’s power supply. The POWER button (15)
sets the device in two possible states:
1. When the POWER-LED (11) illuminates orange, the device is in Standby mode. By pressing the POWER
button (15) or the Power button on the remote control, the device can be switched on.
2. When the POWER-LED (11) illuminates red, the device is switched on and ready. By pressing the POWER
button (15) or the Power button on the remote control, the device can be switched off.
How can I choose the source for the 102?
You have the option to reproduce music by a CD or throughout one of the two digital inputs. By pressing the INPUT
button (6) you can toggle between the three different input sources. With the STATION +/- buttons on the remote
control, you can also toggle between the input sources, as far as the function is activated in the MENU. Please read
the chapter SETUP MENU beginning on page 16.
What are the BURLINK interfaces for?
The BURmester-Link connections RS-232 (16) and USB (17) are for remote controlling the device via PC,
Crestron
TM
or AMX
TM
systems. You can control all of the Burmester devices across this interface, so you do not need
many different remote controls anymore. If you have questions regarding these systems, please ask your
specialized dealer. You can find the Burlink commands on page 19.