TROUBLESHOOTING
The devices cannot be switched on:
Has the AC mains switch (18) been set to ON?
If the Power-LED (11) does not turn on, when the AC mains switch (18) has been set to ON, it is possible that a
fuse inside of the device is broken. Please contact your specialized dealer.
If the Power-LED (11) is illuminating orange, but the device wont power on, it is also possible that one of device’s
fuses is broken. Please contact your specialized dealer.
After the CD has been read-in, “NO CD” is shown in the display:
The 102 CD-Player is only capable of reproducing audio CDs. If you insert a CD, which the CD can not read, the
message „NO DISC“ is shown in the display.
When I choose a digital input source, the name of the input is blinking in in the display.
Why?
If the input sources RCA (27) or TORX (28) do not have a valid signal (or do not receive a signal at all), the indicator
will blink in the display. Possible sources of error can be:
- Is there a cable connected to the chosen input source at all?
- Is the device, which is connected to the 102’s input, switched on and playing?
- Is the connected device delivering a valid S/P-DIF signal?
To Next Page
Loading...
