BURNiT Lambda series - Page 19

19
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
TECHNICAL PASSPORT. INSTALLATION and OPERATION MANUAL
Tightlyclosing thedoors iscontrolledby
hexagonal plate (A) located under each
hingenut(B).
Diagram 13
2.Cleaningofthefaninbackboilerpart.
Use a switch S13 to remove the nuts (4
pieces)thatsecurefanplate.Disassemble
thefanwithplate.It ispossiblethatthe
plate is stuck to the gasket. Thoroughly
clean the fan turbine by using a brush.
Remove the ash and soot accumulaon
intheplacewherethefanwasmounted.
Replace the plate gasket with new one.
Assemblethefanbacktotheboiler.
3.Cleaningofboilerupperchamber.
Disassemble protecve steelplatesfrom
the upper chamber and clean the area
behindthem.
Thoroughlycleantheashusinga paddle
brush and a vacuum cleaner (hoover).
Assemble protecve steel platesbackto
the upper chamber. Make sure they are
properlyseated.
Dismantlingoftheprotecveplates
1.Theplateisrivet-mounted.
2. Slide the plateupwards so as to catch
therivetinthewideporonoftheslot.
3.Pullthereleasedplateaway.
Diagram 14
4. Cleaning of boiler lower chamber /
Diagram16/.
Disassemble ceramic elements from
lower chamber. Follow the sequence of
diagram.
Diagram 15
•Disassembletheboomceramicpartof
combusonchamber(1and2).
•Disassemble both ceramic sides by
smoothrotaonofthedetail(3and4).
•Disassemble back ceramic part: step
one-pulltheboompartforward;step
two-twistthedetailandtakeitout(5).