2.0 Operation
2.1 DAB radio mode
2.2 Scanning for stations
This section describes the operating functions available for each of the audio
sources.
To enter DAB mode
Press Mode until the display shows DAB
6
1.The first time you use AURORA or if the station list is empty the radio automatically
performs a full scan to see what stations are available.
2.You may also need to start a scan manually to update the list of stations for one of the
following reasons:
New stations may become available from time to time.
Stations close or can no longer be received (In the station list, invalid stations are
indicated with a question mark in front of their name).
If reception was not good for the original scan (for example the antenna was not
up), this may result in an empty or incomplete list of available stations.
If you have poor reception of some stations causing the audio to break up, you
may wish to list only stations with good signal strength.
2.3 To do a full scan
1.Press and hold the button.Press on the SELECT dial to start search
2.Once a scan is complete, the radio returns to
playing the previously-selected station or first
station on the station list.
To remove stations that are listed but unavailable
1.Select > Then select PRUNE.
2.This removes all invalid stations, indicated in the station list with a ‘?’ in front of the
station name and populates the memory with updated stations.
Menu
Info
Menu
Info
To Next Page
Loading...
