Getting to know your TV
You’ll be up and running in no time
Getting to know your TV
13
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105.
Aerial connection
Connect the aerial TV plug to the AERIAL INPUT (ANT)
socket located on the back of the TV.
Inserting Batteries into the Remote
Control
1. Remove the screw that secure the battery
compartment cover on the back side of the remote
control first.
2. Lift the cover gently.
3. Insert two AAA batteries. Make sure the (+) and (-)
signs match (observe correct polarity).
4. Place the cover back on.
5. Then screw the cover back on again.
Power connection
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz socket. After unpacking, allow the
TV set to reach the ambient room temperature before
you connect the set to the mains. Plug the power
cable to the mains socket outlet.
Switching On/O
To Switch the TV On
Connect the power cord to a power source such as a
wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode either:
• Press the Standby button, Programme +/- or a
numeric button on the remote control.
• Press the side function switch on the TV until the TV
comes on from standby.
To Switch the TV O
Press the Standby button on the remote control or
press the side function switch on the TV until the TV
switches into standby mode.
To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched into standby mode, the
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active.
The LED can also blink when you switch on the TV
from standby mode.
Changing Channels and Volume
You can change the channel and adjust the volume by
using the Programme +/- and Volume +/- buttons on
the remote.
Fig 2.
Fig 3.
To Next Page
Loading...
