Connections
Bringing it all together
Connections 19
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105.
• To enable PC/YPbPr audio, you will need to use the
side audio inputs with a YPbPr/PC audio cable (not
supplied) for audio connection.
• If an external device is connected via the SCART
socket, the TV will automatically switch to AV mode.
• When receiving DTV channels (Mpeg4 H.264) or
while in Media Browser mode, output will not be
available via the scart socket.
• When using the wall mounting kit (available from
third party in the market, if not supplied), we
recommend that you plug all your cables into the
back of the TV before mounting on the wall.
• Insert or remove the CI module only when the TV
is SWITCHED OFF. You should refer to the module
instruction manual for details of the settings.
• The USB input of your TV supports devices up to
500mA. Connecting devices that have current value
above 500mA may damage your TV.
• By connecting an HDMI cable to your TV, you have
to use only a shielded HDMI cable to guarantee
a sufficient immunity against parasitic frequency
radiation.
First Time Installation
When turned on for the first time, the language
selection screen is displayed. Select the desired
language and press OK.
On the next screen, set your preferences using the
directional buttons.
Note: Depending on the Country selection you may
be asked to set and confirm a PIN at this point. The
selected PIN cannot be 0000. You have to enter it if
you are asked to enter a PIN for any menu operation
later.
About Selecting Broadcast Type
Digital Aerial: If Digital Aerial broadcast search option
is turned on, the TV will search for digital terrestrial
broadcasts after other initial settings are completed.
Analogue: If Analogue broadcast search option is
turned on, the TV will search for analogue broadcasts
after other initial settings are completed.
Additionally you can set a broadcast type as your
favourite one. Priority will be given to the selected
broadcast type during the search process and the
channels of it will be listed on the top of the Channel
List. When finished, press OK to continue.
You can activate Store Mode option at this point.
This option will configure your TV’s settings for store
environment and depending on the TV model being
used, the supported features of it may be displayed on
the top of the screen as an info banner. This option
is intended only for store use. It is recommended to
select Home Mode for home use. This option will be
available in System>Settings>More menu and can be
turned off/on later.
Press OK button on the remote control to continue.
After the initial settings are completed TV will start
to search for available broadcasts of the selected
broadcast types.
After all the available stations are stored, scan results
will be displayed. Press OK to continue. The Edit
Channel List menu will be displayed next. You can edit
the channel list according to your preferences or press
the Menu button to quit and watch TV.
While the search continues a message may appear,
asking whether you want to sort channels according to
the LCN(*). Select Yes and press OK to confirm.
(*) LCN is the Logical Channel Number system that
organizes available broadcasts in accordance with a
recognizable channel number sequence (if available).
Note: Do not turn off the TV while initializing first
time installation. Note that, some options may not be
available depending on the country selection.
To Next Page
Loading...
