Bush T-701 - Changing the Password

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting section of these instructions
32
Using your DVD player
Let’s get started
Changing the password
To change the password -
1 Press the SETUP button and use the NAVIGATION buttons ( ) to
display the PASSWORD menu.
2 Enter the submenu by pressing the NAVIGATION ( ) button, then
use NAVIGATION buttons ( ) to highlight PASSWORD and press the
ENTER button to confirm.
3 Use the NAVIGATION buttons ( ) to highlight PASSWORD (change)
and press the ENTER button to confirm the selection.
4 Enter the pass code (1369) and then enter the new pass code twice,
before pressing the ENTER button to confirm.
5 The new pass code has now been set.
6 Press the SETUP button to exit this feature.
Note:
 See troubleshooting section for action to be taken for forgotten
passwords.