EN
Page 56 of 61
INSTRUCTION, USE AND
MAINTENANCE MANUAL
15.0 ERROR SIGNALS
During wheel balancer operation, if wrong commands are given by the operator or device faults occur, an error
code may appear on the monitor screen.
Below is a troubleshooting chart.
Error code Description
2 Planned wheel speed not reached
3 Calibration overcoming
4 Wheel speed stability out of tolerance
5 Encoder calibration error
6 Encoder samples not sufficient
7 Chuck calibration error
8 Piezo calibration values out of tolerance
9 Wheel rotations not completed
11 Incorrect gain calibration
14 Firmware error
15 Runout samples not sufficient
28 Piezo calibration error
29 Distance out of tolerance level
31 Distance-diameter caliper released
32 Parameters format incompatible
LIBRAK350 - LIBRAK350PRO
1296-M024-01
To Next Page
Loading...
