TRANSPORTATION AND STORAGE
USER MANUAL
36
EPS14Pi
37
Caution
(1) Appoint an administrator to supervise.
(2) Check whether the ground is hard enough so as to prevent the ground from sinking when
loading forklifts.
(3) Use a solid block to fix the transport truck.
(4) Test the strength and stability of the ramp everywhere during loading and unloading.
TRANSPORTING AND UNLOADING
(1) Transport forklifts with trucks or flat trucks.
(2) The procedures of unloading by lifting is consistent with those of loading.
(3) Remove forklifts slowly from transport trucks. Other requirements are same as those of
loading forklifts.
STORAGE AND RESTARTING
PROCEDURES OF STORAGE
Clear all dusts on the parts of forklifts and operate as follows.
(1) Check whether there are oil leaks, water leaks, or abnormal parts. If any, please repair
first.
(2) Carry out complete lifting and lowering operation for several times.
(3) Lower down the fork.
(4) Apply a thin coat or grease to all unpainted parts.
(5) Check the level of hydraulic oil. If necessary, add it.
(6) Lubricate all components completely.
(7) Pull out the key and ensure the electrical appliances in a rest state. Press the
emergency stop switch, and make sure the battery power is controlled around 50%. Do
not place with feed or full power for a long time.
(8) Operate the vehicle monthly.
PROCEDURES OF RESTARTING
Clear all dusts on the parts of forklifts and operate as follows.
(1) Lubricate all components completely.
(2) Lift and lower forks, forward and backward tilting masts for several times. If fitted with
an accessory, operate it several times.
(3) Check the charging of battery.
(4) Check hydraulic and replace it if necessary.
For the first use after long-term storage, the forklift must be checked and tested before
it can be used.
Caution
OM-EPS14Pi2019001-
E
N
To Next Page
Loading...
