QT601-2 Quantec Controller

Installation & Programming Manual • Approved Document No. DNU6012001 Rev 5 • Page 34 of 42

Pre-Commissioning Certificate

When the Installing Contractor has carried out the various test/checks highlighted in these Pre-Commissioning Instructions, this

certificate should be completed, signed and left for the attention of Commissioning Engineer:

Checks carried out to the following:

Tested and Faults found

working correctly and not corrected

Spine Wiring 

Limb Wiring 

Call Points 

Overdoor Lights 

Ceiling Pulls 

Slave Call Points 

Tail Call Leads 

Infrared Ceiling Receivers 

Displays 

Monitoring Points 

Addressable Overdoor Lights 

Addressable Sounders 

Cables clearly labelled?  Yes  No

SIGNED:_______________________________________ DATE: ____________________________________________

CONTRACTORS NAME: ___________________________________________________________________________

COMPANY: ______________________________________________________________________________________

ADDRESS: _______________________________________________________________________________________

TELEPHONE: ___________________________________ FAX: _____________________________________________

DETAILS OF ANY FAULTS: _________________________________________________________________________

________________________________________________________________________

C-TEC QT601-2 User Manual

Other manuals for C-TEC QT601-2