To Next Page

To Previous Page

47cab Produkttechnik GmbH & Co KG

16 4 17 13 18

Fig. 7f Loading Labels from Roll in Rewind Mode

7. Media Loading

12. In rewind mode, the rewind guide plate (16) must be mounted.

Remove the labels from the first 4 in (100mm) of the label strip.

Then, slide the media strip (4) around the rewind guide plate (16) to the

internal rewind hub (13) as shown in figure 7f. Slide the strip under the

clamps (17) that are located on the internal rewind hub (13). Hold the

internal rewind hub (13) and rotate the nut (18) counter-clockwise until it is

tight. The media strip will now be fastened to the internal rewind hub (13).

Rotate the internal rewind hub (13) counter-clockwise to tighten the media

strip.

Other manuals for CAB A4

Questions and Answers:

Need help?

Do you have a question about the CAB A4 and is the answer not in the manual?

General

Printer Type	Thermal transfer / direct thermal
Interfaces	USB, Ethernet, RS232
Label Thickness Range	0.05 mm - 0.25 mm
Memory	8 MB Flash
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	+5°C to +40°C
Print Resolution	203 dpi
Humidity Range	10-85% non-condensing