CAB HS Series - HS+;VS+ Operation Modes

1514
4.2.2 Operation Modes
 Check the operation mode by means of the LEDs (2 / 3 / 4).
 Touch button for changing the operation mode.
Automatic Peel-Off
 After switching in the "Automatic peel-off" mode the rst label will
immediately be fed to the peel position.
 Take the label.
The next label will be fed to the peel position.
!
Attention!
Risk of unintended start-up.
 Do not touch the feeler of the present sensor excepting the
error treatment.
Peel-Off on Demand
 For peeling-off a label touch button .
 Take the label.
 For peeling-off the next label touch button again.
Peel-Off on Demand with External Control

for devices with peripheral port only
If an external control is connected LED (2) is illuminated.
i
Notice!
With an external control connected the device cannot be switched to
the "Automatic peel-off" mode.
The release button has no function.
 Send a start signal.
A label will be fed to the peel position
 Take the label.
 Send a new start signal.
4 Operation