CAB HS Series - Unpacking and Setup; Connecting to Power Supply

8 82 Installation
2.2 Unpacking and Setting-up the Device
 Lift the device out of the box and set it up on a level surface.
 Check device for damage which may have occurred during transport.
 Check delivery for completeness.
Contents of Delivery:
• Label Dispenser
• Margin Stop
• Power Cable Type E+F
• Operator's Manual German / English
i
Notice!
Please keep the original packaging in case the device must be
returned.
!
Attention!
The device and materials will be damaged by moisture and wetness.
 Set up the device only in dry locations protected from splashed
water.
2.3 Connecting the Device
1
2
3
1 Power switch
2 Power connection jack
3 Peripheral port for external control
(HS+/VS+)
Fig. 3 Connections
2.3.1 Connecting to the Power Supply
The device is equipped with a wide area power unit for a supply voltage of
100 V to 240 V.
1. Check that the device is switched off.
2. Plug the power cable into the power connection jack (2).
3. Plug the power cable into a grounded socket.