CAB PS5 - Operation; General Settings

8 84 Operation
4.1 General Settings
 Activate the peel-off mode in the software.
In direct programming use the "P" command.
 Programming Manual of the printer.
 Congurethepeel-offparameters.
 „5PrinterConguration“
i
Note!
The peel-off parameters are only accessible with a peel-off adapter
or present sensor only.
On the back side of the modules there is a jumper system with 4 possible
jumper settings.
 For PS5 set the jumper to JP1 or JP2 to select the mode.
 For PS6, PS6V and PS8 the jumper must remain at position JP4
 For PS9 the jumper must remain at position JP1