8059 Dual Input Channel 5-3
Revision J2005-2 J-Type
81416 53G%#3DG
The “-20” switch puts a 20dB attenuation pad in series with the I/P signal.
Use the -20dB when the input signal is at line-level or to reduce the overall input gain
by 20dB.
81417 7;9#3KDQWRP#SRZHU
The 48V switch connects phantom power to the I/P line and can be used to feed
most makes of capacitor microphones.
81418 3KDVH#F KDQJH
Use this switch to change the phase of the I/P signal.
When this function is selected, the incoming signal has its phase changed by 180º.
81419 ,QSXW#21
Switches on each input which can be on at the same time. The result is a mix of both.
8141: 26&231*#%XV#6HOHFW
This switch connects the OSC/PNG bus to the input amplifier.
You may select a sine wave tone for line-up purposes, or pink noise for loudspeaker
calibration (selectable on OSC/PNG/COMMS module).
8141; 3UH#(4
Sets direct output to pre/post EQ
8141< 3UH#)$'
Sets direct output to pre-fader.
814143 'LUHFW#2XWSXW#/HYHO
Presets the direct output level.
814144 5RXWLQJ#WR#6XE#*URXSV
Switches select the Input routing to the Sub Groups.
814145 6XE#*URXSV#,1
Enables sub group panning
To Next Page
Loading...