Pag. 72 MIRIAM-NICE-DIANA-PRETTY-MARY
4.2. INSTALLATION
We recommend installing the stove with a clearance from any walls and/or furniture of at least 150mm to
allow effective cooling of the appliance and good heat distribution in the room. Fire-fighting safety
regulations lay down the distance from objects that are inflammable or heat sensitive (sofas, furniture,
wood cladding, etc.) as shown in Picture 10. In the case of highly inflammable objects (curtains, carpets,
etc.) the distance is increased to 1 meter.
If the floor is combustible material, it must be protected by non-flammable material (steel plate,
refractory material, marble …) see dimensions in Picture 10.
Picture 10
The stove must be installed on a floor that will withstand its weight (see paragraph 9.4, page 88-89). If
the existing construction does not meet this requirement, appropriate measures must be taken (for
example, load-distributing plate).
4.3. ELECTRICAL CONNECTION
IMPORTANT: THE APPLIANCE MUST BE INSTALLED
BY A SPECIALIZED FITTER.
The electrical connection is by cable with a plug suitable for the specific load and voltage of each model,
as shown in the technical data table (see paragraph 9.4, page 88-89). The plug must always be
accessible. Take care that the cable does not come into contact with hot parts of the stove. Also make
sure that the electricity mains is efficiently earthed. If this is not so, bring up to legal standards. If the
power lead is damaged it must be replaced by a qualified electrician.
4.4. CONNECTION OF EXTERNAL THERMOSTAT
The stove operates with an internal thermostat probe (see Picture 16, page 87, Detail 10 – Room
Probe). If required, stove can be connected to an external thermostat. Make sure it is not near any heat
sources. These operations must be performed by a specialized fitter.
To Next Page
Loading...
