Program
Does this
Is used for this
Prime
Repeatedly cycles battery
until maximum capacity is
reached. If capacity
improvement is more than
5% over previous reading,
an additional cycle is
applied.
• Preparing new batteries for field
use.
• Conditioning batteries that have
been in storage.
QuickSort
Estimates battery capacity
using an inference
algorithm.
For Li-Ion, 3.6V, 500 –
1500mAh
16K Battery Adapters only
(adapters are identified with
a “16K” sticker on the back)
• To rapidly sort batteries.
• A ‘universal’ rapid test for Li-Ion
batteries.
• Can be used with the FlexArm
07-110-0180 or RigidArm 07-
110-0190
Auto
Function: Exercises batteries to maintain optimum performance. This is the
recommended program for routine maintenance of batteries. It reconditions NiCd
and NiMH batteries that do not reach Target Capacity. Li-ion, Li-Ph and SLA
batteries are not reconditioned, only exercised. Batteries in use are typically cycled
every three months on Auto. If batteries are failing prematurely, increase the
frequency of service on the Auto program.
Sequence: The battery is first cycled (charged and then discharged) to determine
it’s true capacity. If NiCd and NiMH batteries do not meet the target capacity at the
end of the discharge cycle, they are reconditioned to reduce battery memory.
Following recondition, the battery is cycled again to determine the recovered or
final capacity. The battery is fully charged when the program completes.
SLA, Li-ion and Li-Ph batteries are cycled once. If the target capacity is not
reached in the first cycle, it is cycled again. Recondition is not performed for Li-ion,
Li-Ph and SLA batteries.
Cadex Electronics Inc. C7000-C Series Battery Analyzers .
26
To Next Page
Loading...
Need help?
General
