- Use BATTERYSHOP to use the unit with Cadex analyzer
BatteryShop™ software.
- Use TERMINAL to connect to a computer to display and analyze
service data (see Logging Data, page 91)
- Use LABEL MAKER to connect to a Dymo-CoStar SE300 label
printer.
- Use PRINTER to connect to a serial dot matrix Epson
compatible printer. Since serial printers are no longer
available, use the USB port or a SP-2 converter (see Appendix
D - Parts and Accessories, page 154)
- DISABLED if there are no devices connected to a serial port.
5. Press ENTER.
6. Press or to scroll to YES to accept changes and press ENTER.
7. Press to scroll to SERIAL PORT SETTINGS and then press ENTER. Skip
this step if connecting to BatteryShop or the Dymo-CoStar SE300 label
printer.
8. Enter the required settings as specified in the device user’s manual
(see above for available options):
Press or to move the cursor from option to option.
Press or to scroll through available settings.
9. Press ENTER.
10. Press or to scroll to YES to accept changes and press ENTER.
11. Press ESC twice to return to the global display.
Typical Serial Cable Pin Configurations
Note: Do not use these configurations for the Dymo SE300 printer. Use the cable
that is supplied with the printer.
73
To Next Page
Loading...
Need help?
General
