Starting an ESD Simulation
78
CAEEndoVR
PN: 165K400000
There is a sequence of steps required to use the tools:
1. Select the desired tool in the TOOLS menu on the left screen
2. Insert the plastic filament in the working channel of the endoscope until the tool appears
in the ENDOSCOPIC VIEW or EXTERNAL VIEW
3. Insert the filament further in the working channel to advance the tool
4. Pull the filament to retract the tool into the scope
5. Push the finger loops of the snare tool to open the coagrasper, extend and open the
endoclip or to retract the other tools
6. Pull the finger loops of the snare tool to close the coagrasper, close and retract the
endoclip or to extend the other tools
Note: : Endosclips are automatically reloaded by removing and re-inserting the snare tool filament.
To Next Page
Loading...